How does the XR2206 function generator work?

d that show you where each component should be placed.The XR2206 Function Generator can generate three types of stable wave forms (sine, triangular, and square wave) with a freque cy range from 1Hz to 1MHz and an adjustable amplitude. It ses an AC/DC power adapter (9-12Vdc, 30mA of current).Ple se note, this item ships from an

How do I test a function generator?

the function generator, apply a 9 to 12V power supply. You will need an oscilloscope to test this kit, such as the low-cost DSO138 digital oscillo cope, which will be reviewed in another, future issue. This follo ing pictures are from my Z-100 Heathkit Digital Scope.Here are the sinusoid

How do you ground a generator?

Ground the generator by tightening the grounding nut on the front control panel (Fig. 10) against a grounding wire. A generally acceptable grounding wire is a No. STARTING THE GENERATOR Before starting the generator, make sure you have read and performed the steps in the “Generator Preparation” sec- tion of this manual.

How do you disassemble an engine cylinder block?

(1) Remove the anifold (TM 5-6115-440-20).(2) Remove the cylinder head ( 3- 3).(3) Rem ve the piston and connecting rods (para 3-23).(4) Refer to figure 3-2 and remove the engine cylinder block c. Disassembly. Refer to figure 3-27 disassemble the engine cylinder block.andd In pection.In

What should I do if my generator is not working?

o switch to OFF or STOP position. Do not attempt to chang connects when generator is running. Before servicing any part of a generator set, make sure unit is completely de-energized.DANGEROUS GASESare generated as a result of o erating of this equipment.DEATHor severe injury may result if personnel fail to observe safety precautions.Utiliz

How do you add gas to a generator?

Place the generator on a level surface. Make sure the engine is OFF before adding or checking oil. 2. Remove and wipe the dipstick with a clean rag. Upper Limit 3. Page 16 GENERATOR PREPARATION TO ADD GASOLINE: Fig. 6 Fuel Fuel Cap 1. Place the generator on a level surface. Make sure the Gauge engine is OFF before adding or checking the fuel.