How far should a clamp be connected to a PV module?

Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load. *Note: The above-described distance is from the module edge to the middle of the clamp.

Are there any UK standards relating to a PV installation?

While many UK standards apply in general terms, at the time of writing there is still relatively little which specifically relates to a PV installation. However, there are two documents which specifically relate to the installation of these systems that are of particular relevance:

What is the maximum voltage a photovoltaic module can run?

For roof use, the maximum system voltage must not exceed 600V according to National Electrical Code. Under normal conditions, a photovoltaic module is likely to experience conditions that produce more current and/or voltage than reported at standard test conditions.

Are all PV products covered by IEC61730 'photovoltaic (PV) module safety qualification?

In future it is expected that all PV products will increasingly be covered by International standard IEC61730: 2004 ‘Photovoltaic (PV) module safety qualification’.

What is the minimum wire size for a solar PV system?

JA Solar recommends installers use only sunlight resistant cables qualified for direct current (DC) wiring in PV systems. The minimum wire size should be 4mm2. Rating Required Minimum Field Wiring Cables should be fixed to the mounting structure in such a way that mechanical damage of the cable and/or the modules is avoided.

What are the requirements for a PV installation?

Virtually all domestic PV installations will fall under the scope of Part P. Part P requires the relevant Building Control department to be notified and approve the work. There are two routes to comply with the requirements of Part P: Notify the relevant Building Control department before starting the work.