Where should Jinko PV modules be installed?

Jinko PV modules should be installed in suitable locations. Do not install the mod-ules in places that could be flooded. Be careful when installing the photovoltaic modules particularly at the corners of the racks or trackers.

What should I know before installing Jinko Solar?

as may be present.Do not remove any part installed by Jinko Solar or dis le the module. All instructions should be read and understood before attempting to install, wire, operate and ain the module. Don’t lift up PV modules using the attached cables he junction box. Do not touch live termin

What should I know about Jinko Solar?

ections. Do not remove any part installed by Jinko Solar or disassemble he module.All instructions should be read and understood before attempting to install, wire, operate and maintain he module.Don’t lift up PV modules using the attached cables or the j ction box.All PV systems must be ground

Can JinkoSolar PV modules be installed in permanent shading conditions?

Operation in permanent shading conditions is not recommended. Do not install the PV module near open flame or flammable materials. JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test (test method 6). PV modules can be installed at a distance of 50m away from the seashore.

Can Jinko Solar be used to replace a roof?

Do not use the module to replace or partly replace roofs and walls of buildings. Do not remove any part installed by Jinko Solar or disassemble the module. Don’t lift up the modules using the attached cables or the junction box.

What pressure does a Jinko module meet?

er stickers match.Jinko modules are designed to meet a maximum positive (or downward) pressure of 3600Pa (Only refer to the mentioned module type in this manual) and negative (or upward) pressure of 1600Pa. This design load was then tested with a safety